Faux-biased pieced binding

It’s faux-biased because the strips are cut on the straight grain, but the ends are sewn diagonally to give it a biased look. This technique can also be used when piecing borders.

Line up fabric strips like so and mark seam line with a pen or pencil

Sew along marked seam line

And voila



Strip-pieced sashing

Strip-pieced sashing

A group project for a co-worker’s baby. I put the top together. This was my first time doing a strip-pieced setting, using scraps from everyone’s squares. i also made the fox and the tree squares. i found inspiration for this quilt here.

Pieced Bias Binding

pieced bias binding

Usually I use the continuous bias binding “tube method.” But I thought this quilt called for a pieced binding. It came together surprisingly fast. Here are the steps I used. I borrowed these from Jaybird’s blog with modifications.

  • Sew strips together. I used varying widths and lengths. My strips were between 3 and 6 inches wide, and a multitude of lengths, but you could make them all the same width if you want. When I joined them I staggered the strips by 2 inches to save fabric. Hint: Don’t make your strips sets wider than you can easily cut with your ruler.
  • Press seams open.
  • Cut binding strips at a 45 degree angle using either your cutting mat or your acrylic ruler. You may have to cut 45 degree angles on some of the ends, too. I cut my binding strips at 2-1/4 inches wide. I’ve done a lot of 2-1/2 inch wide bindings, too.
  • Join the strips until you have an amount equaling the perimeter of your quilt plus about 18 inches to finish the binding.
  • Fold binding lengthwise in half and press.

When I started doing this I thought it was going to be hard to get enough usable binding, but after you cut as much as you can and join it all together, you’ll find you have a lot more than you thought.

View the finished product here.